SKC-S Cleaner

Package Size

Choose an optionBulk 25LBulk 4×5LAerosol can 400mlCase of aerosols 10×400mlClear

SKC-S Cleaner quantity

Add to cart

Add to quote

Product added to quote

View/Send Quote Request

Description

Product information

Magnaflux SKC-S Solvent Based Developer

SKC-S is an NDT-approved solvent cleaner/remover for pre-cleaning before non-destructive testing and
for removing excess surface penetrant from an inspection area before applying developer during liquid
penetrant testing.
This non-halogenated solvent remover can be used on a wide range of substrates to remove oils,
greases and other contaminants. SKC-S dries quickly without leaving a residue, and meets the low residue requirements for NDT and aerospace penetrant testing.

Benefits

Maximize range of inspections

• Inspect a wide range of components without worry
• Conforms to AMS 2644 Class 2, ASME BPVC and all major aerospace requirements

Application versatility

• Use a single cleaner throughout the entire penetrant testing process
• Comes in both bulk and aerosol forms, or as part of a kit for convenience

Minimize risk of missing a flaw

• Inspect reliably by cleaning only the surface without flushing penetrant out of discontinuities
• Dries quickly without leaving residue to prevent false indications

Features

• AMS 2644 Class 2 nonhalogenated remover
• Fast drying
• Leaves no residue
• Suitable for use at low temperatures
• Alloy compatibility
• Bulk or aerosol form
• Doesn’t over clean

Specification compliance

 

• AECL
• AMS 2644
• ASME BPVC
• ASTM E1417
• ASTM E165
• Boeing BAC 5423 PSD 6-46 or 8-4
• Boeing PS-21202
• General Electric P50YP107
• ISO 3452-2
• MIL-STD-2132
• MIL-STD-271
• NAVSEA 250-1500-1-REV-1

 

Properties

Flash Point	> 57°F / 14°C
Density	6.29 lb/gal / 755 g/L
Corrosion	Meets AMS 2644 requirements
Non Volatile Residue	<50 ppm
NPE Free	Yes

Applications

Defect location: open to surface

Ideal for:

• Non-destructive testing pre-cleaning
• Removing excess surface penetrant
• Post inspection cleaning
• When chlorinated solvents are undesirable or
  prohibited

 

Instructions for use

For NDT pre-cleaning:

1. Spray the surfaces to be cleaned liberally with the cleaner then either wipe off or allow to air dry, or soak a clean cloth with the cleaner and wipe the part clean.

2. Allow the part to dry thoroughly before applying the penetrant.

To remove excess surface penetrant:

1. Apply SKC-S to a cloth, wipe test surface and repeat as needed.

2. Do not spray SKC-S directly on the part because penetrant indications may be removed.

Request a free quote today.

View instructions on the process of penetrant testing.

Additional information

Manufacturer	Magnaflux
Package Size	Bulk 25L, Bulk 4×5L, Aerosol can 400ml, Case of aerosols 10×400ml